This receiver is a frequency hopping spread spectrum design which means it it constantly changing channels looking for the most clear signal possible. This receiver works with normal voltage or high voltage applications (4.8 - 7.4V) so you can use a standard ESC, BEC, SBEC, UBEC or you can power it from an external battery pack. This receiver will also work with the Futaba 14SG radio since the 14SG will work with FASST, FHSS, and FASSTest receivers. Afficher la fiche produit.įUTL7606 Futaba R2006GS 6 channel S-FHSS Receiver The Futaba R2006GS 6 channel SFHSS receiver is compatible with the Futaba 6J and 8J radios. Recepteur R2006GS 2.4GHZ Futaba 6 Voies FHSS. Futaba R2006GS 2.4GHz 6-Channel S-FHSS Receiver. FrSky 2.4G 7Channels Receiver TFR6 Compatible with Futaba FASST System. Proform j6 target pulse treadmill price 2017. you could loose control of your quad if the controller voltage drops too low.Includes transmitter, receiver, instruction manual, neckstrap. If your battery is old its wise to buy a new one. Battery's can actually show full voltage until they're actually put to use and then QUICKLY drop in voltage if the battery is old or unhealthy. If you haven't flown in a while your Controller battery may not hold a charge as well as it did when it was new. This model is designed for short range The R2106GF is compatible with the S-FHSS/FHSS transmitters as shown below. Once it turns green your controller and receiver are again bound together. User Manual 1 pgs 183.91 Kb 0 Futaba R2106GF User Manual Download for 1 For Park Flyers and Slow Fly models R2106GF Thank you for purchasing the R2106GF S-FHSS 6 (six) channel receiver. Once your sure the Range Test is off, go through the binding procedure you did before and once you get the flashing red light on the Futaba receiver give it enough time to turn green. Go through that part of the manual and be sure the Range Test is turned off. If its close, your controller battery is probably OK and you should then find the section in the manual that talks about TJ8 range test. Just compare what the manual says against what your controller still shows on its screen (7.6v ?). You need to check your T8J manual to find out what the acceptable voltage for the TJ8 controller battery should be. Click to expand.The Tx (transmitter) and controller are actually the same thing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |